stick-slip
美 
英
英汉解释
例句
Wheel squeal is associated with a complex combination of creepage and a mechanism known as stick-slip.
车轮的尖啸噪声与蠕滑及粘滑的组合机械运动有关。
The abrupt disappearance of stick-slip at the lower speed level is attributed to changes in the elastic deformation of the fiber.
在低速水平时，粘滑现象也消失，这是由于纤维弹性变形的改变。
The results showed that the criterion can correctly predict whether stick-slip will occur directly from working parameters.
实验结果表明，使用该判别式能够直接根据工况参数正确预测气缸是否出现爬行现象。
The torque feedback system is a successful technology for eliminating stick-slip vibration of drill-string assembly.
扭矩负反馈减振是控制和消除钻柱周向粘滑振动较为有效的方法之一。
Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.
粘附滑移流动是一种密集颗粒的急跳式的运动，在壁面处，颗粒的速度稍低于呈杆状的中心的速度。
The system steady-state error and the stick-slip phenomenon caused by the nonlinear friction are analyzed.
分析了由非线性摩擦力矩引起的系统稳态误差及粘滑振荡现象；
The friction between gabbro and marble exhibited stick-slip with visible displacement weakening.
辉长岩与大理岩之间的摩擦出现粘滑，位移弱化现象非常显著。
there is no stick-slip effect of rolling contact bearings, starting torque is small, run a small friction.
滚动接触轴承没有粘滑效应，起动转矩小，运行摩擦力小。
This same stick-slip mechanism has been strongly implicated in the formation of short-pitch corrugation and associated roaring noise.
短波的波浪磨耗的形成及由此产生的轰鸣噪声也与这种粘滑机械运动密切相关。
It will also provide additional diagnostics on stick slip, shaft integrity, and maximum and minimum torque.
其还将提供额外的粘滑运动诊断，轴的完整性和转矩的最大化和最小化。
The results show that Huangcaoba faults latest activities for the holocene early, and fault was dominated by stick slip.
结果表明黄草坝断层最新活动时代为全新世早期，且活动方式以粘滑为主。
Once the force generating the creepage is spent by the sliding 'action, the stick-slip process begins again (Figure 1).
当产生蠕滑的力被滑动过程消耗以后，下一个粘滑过程又会重新开始。（见图1）
The goal of the study is to develop a system to measure temperature change in the operation of the stick-slip actuator.
本次研究的目的是开发一种温度测量系统来测量粘滑驱动器在运行中的温度变化。
to ensure continuous and stick-slip free operation.
为确保持续和声滑自由运作。
The friction plays an active role in the stick-slip actuator.
摩擦在粘滑驱动器中具有积极的作用。
Sun Waylubes 1180 and 1190 can improve machining precision due to elimination of stick-slip and chatter of slideways .
太阳1180和1190导轨油可以消除粘着与滑动的合并动作或震动的现象，故可以提高机械加工的精密程度。
In order to eliminate the stick-slip phenomenon, a linearization of the nonlinear model is made at the middle point of the cylinder.
为了消除爬行运动，在气缸中间位置对系统非线性模型实行局部线性化，分析提出压力反馈和摩擦力动态补偿的方法。
For limestone no stick-slip was observed.
石灰岩实验未观察到粘滑现象。
the stress drop and axial displacement in stick slip were much less than that in the eventual fracture.
粘滞时的应力降和轴向位移的变化比断裂时要小得多。
Macroscopic and Microscopic Evidence of Periodical Stick-Slip Deformation in an Active Fault
活动断层周期性粘滑变形的宏观和微观证据
Modeling of a Stick-slip Friction Pair and its Application on the Dyanmics of Railway Vehicles
磨擦副仿真模型研究及其在机车车辆动力学中的应用
Numeric Simulation on Destructive Effect of Golmud- Lhasa Railway Resulting in Stick-Slip Movement of the Eastern Kunlun Fault
东昆仑断裂粘滑错动对青藏铁路变形效应的数值模拟
Mechanism Analysis on Torsional Stick-slip Vibration of Drillstring in Extended Reach Well and Some Ways to Its Suppression
大位移井钻柱粘滑振动机理分析及减振研究
Study on Hydraulic Limps Depart Stability in the Stick-slip Friction Effects on the Hydraulic Elevator Actuator
液压缸粘性摩擦对液压电梯起动平稳性影响的研究
Control of Stick-slip Phenomenon on Silicon Interface under Relative Humidity Conditions
环境湿度下硅材料表面的粘滑行为及其抑制
Analysis on stick-slip resulted in hydraulic system of machine tool and its elimination
机床液压系统产生爬行原因分析及消除
Simulation Analysis of Stiffness and Dampness Ratio for the Stick-slip of Machine Tool
刚度和阻尼比对机床爬行影响的计算机数值模拟
Stick-Slip Criterion of Unsymmetrical Cylinders Driven by Meter-Out Circuit
出口节流调速非对称气缸的爬行判别式
Modeling of the Motion and the Estimation of Stick-slip in Pneumatic Cylinders
气缸运动建模及爬行现象判别
Present research situation and analysis on machine tool stick-slip motion
机床低速爬行研究现状及分析
The Simulation and Active Control Measure of Stick - slip Motion of Machine Tool
机床爬行的仿真研究及控制措施
A Solution of Stick- Slip Motion and Hysteresis for Pneumatic Control Valves
气动控制阀控制系统爬行和滞后问题的解决方法
Modelling and Simulation of Stick-slip Motion in Pneumatic Cylinder
气缸爬行现象的建模与仿真
Nonlinear Stick-slip Friction Compensation for DC Motors
一种直流力矩电机系统的滞滑摩擦补偿方法
Motion Model and Vibration Equation of Machine Tool Feed System in Stick-slip
机床进给爬行时的运动模型与振动方程
Study on Criterion about Overcoming Low-Speed Stick-Slip of Simulator
仿真转台克服低速滞滑的判据研究
Dynamic Analysis of Miniature Piezoactuator Using Stick-Slip Friction Model
基于粘-滑摩擦力模型的微型压电驱动器动力学分析
Optimal control of low speed stick-slip motion of hydraulic servo system
液压伺服系统低速爬行的最优控制
Research on Measurement System of Stick-slip Signal in Machine-Tool
机床爬行信号测试系统研究
Stick-slip Criterion of Cylinder Based on Experiment and Dimensional Analysis
基于试验-量纲分析法的气缸爬行判定式研究
