xrd
美 
英
- 网络X射线衍射仪(X-ray diffractometer)；X射线衍射(X-ray diffraction)；x射线衍射测量术(X-ray diffractometry)
例句
This paper has analyzed the surface and cross-section morphology and the phase composition of the ceramic coatings by using SEM, XRD.
采用SEM、XRD等方法对陶瓷膜的表面微观形貌、结构及成分进行了表征。
The surface appearance and corrosion products of Zn-Mg alloy coatings with different content of Mg were analyzed by SEM and XRD.
采用扫描电镜和X射线粉末衍射，对含镁量不同的热镀锌镁合金镀层表面形貌和腐蚀产物进行了分析。
The structure, pore volume distribution and acid property of these samples were characterized by means of XRD, BET, NH3-TPD and Pyridine-IR.
以XRD，BET，NH3-TPD和吡啶吸附等方法对它们的构型、孔分布和酸性质进行了表征；
The analysis of microstructure and XRD indicates that the bead welding is of good densification and has high combination strength.
通过显微组织、X射线衍射分析表明，所得堆焊层组织致密、结合强度高。
The analysis result of X-ray diffraction (XRD) showed that the crystallinity of the treated silk fiber increased.
X-衍射（XRD）分析表明处理后的柞蚕丝结晶度提高；
The obtained silver nanoparticles were characterized by means of powder X-ray diffraction (XRD) and scanning electron microscope (SEM).
并用X射线衍射（XRD）和扫描电子显微镜（SEM）对所得银纳米杜子进行表征。
The morphology, status, chemical state & properties of the composite deposits were studied by means of SEM, TEM and XRD.
利用SEM，TEM，XRD等方法研究了复合镀层的组织、结构、性能及其影响因素。
Au nanoparticles were characterized by means of scan electron microscope (SEM), scan probe microscope (SPM) and X-ray diffraction (XRD).
利用扫描探针显微镜、扫描电子显微镜和X射线衍射等技术对制备的金胶体进行表征。
The element valence, crystalline phase, microstructure have been studied by means of XPS, XRD and SEM.
压电陶瓷的元素价态，相组成以及显微结构。
The nanoparticle size, and phase were characterized by means of TEM, XRD, TGA, surface area and pore diameter measurements.
通过TEM，XRD，TGA及表面积与孔径测定仪等测试手段对该负载型催化剂的物相、粒子的形貌和粒度进行了表征。
Quality and reliability analysis. AFM as well as the XRD results both demonstrate the good crystallinity of the thin-film after annealing.
质量方面，AFM表面形貌表征显示退火后的薄膜具有很好的结晶度，颗粒饱满、均匀。
XRD and SEM techniques were used to characterize the mullite solid solution synthesized from waste aluminum slag and kaolin.
采用XRD和SEM等测试手段对用铝厂废渣和高岭土合成的莫来石材料进行微观结构表征。
Enhancement mechanism of S-activator on high calcium PFA expansive cement was studied by means of DSC, XRD, SEM, etc.
采用DSC、XRD、SEM等微观分析方法研究了S-激发剂对高钙粉煤灰膨胀水泥的增强机理。
The pattern of XRD illustrated that the pure perovskite phase (tetragonal) had been obtained for all samples.
XRD分析结果表明所制备的样品都生成了纯的钙钛矿结构，并且都为四方相。
By means of XRD and SEM, the microstructure and crystallization phase identification are.
运用XRD、SEM等方法分析了微晶泡沫玻璃的析出晶相和显微结构。
Analysis of ESEM and XRD showed that heavy metals configuration and crystal lattice had been changed after planting.
种植黑麦草后的底泥中重金属的存在形态和晶格结构发生了变化。
XRD analysis of the bar indicated that the main binding contents in the bar are magnesium phosphate and calcium phosphate.
试验结果表明，该体系中的主要胶凝物质为磷酸镁和磷酸钙。
XRD results demonstrate that the crystallization of the carbon spheres improved with the rise of reaction temperature.
X-射线衍射结果表明产物的石墨化程度随反应温度的升高而提高。
However, XRD analysis and corresponding microstructure observations reveal that the aging process is influenced by grain size obviously.
相应的XRD和显微结构比较研究显示，马氏体时效钢的时效行为和晶粒尺寸相关。
It was character ed by XRD, BET method, the reaction kinetics at the catalytic process was also measured.
利用XRD、BET方法对催化剂进行表征，测定了其催化反应过程动力学数据。
XRD and TEM show that the prepared catalysts possess high thermal-stability up to 923K.
XRD和TEM考察结果表明，所制备的催化剂有较高的热稳定性。
The structure, composition, crystalline size and bactericidal capability of the film are studied by the methods of TEM , XRD.
以TEM、XRD等方法对膜材料的结构、组成、晶粒大小、杀菌性能进行了研究。
XRD and IR were used to analyze the effect of different calcination temperature on phase composition of the precursor.
采用XRD和IR分析不同灼烧温度对前躯体物相组成的影响。
A novel 3-D nano-structured ZnO has been prepared by two-step solution method on the surface of silicon and characterized by SEM and XRD.
采用两步溶液法在硅片表面制备了新颖的三维纳米结构氧化锌，并采用SEM和XRD等手段对其进行了表征。
Meanwhile, XRD and TPR techniques are applied to character structure and properties of the catalysts.
同时，采用XRD和TPR表征手段对催化剂进行了表征。
These inclusion compounds were confirmed by means of IR and powder XRD, and their host-guest molar ratio was determined by ^1H NMR.
本文还报道了这些包结化合物的IR，粉末XRD的表征，用^1HNMR谱测定了它们的分子摩尔比。
The mini X-ray diode (M-XRD) was developed, and was used in mini soft X-ray spectrometer.
研制了小型X光二极管（XRD），可用于小型软X光能谱仪。
The range of crystallization temperature, crystalline phase identification and microstructure were observed using DTA, XRD and SEM.
用DTA、XRD和SEM研究晶化温度范围并鉴定玻璃陶瓷主晶相与显微结构。
The micro-morphologies and phase structures of the samples are observed by scanning electron microscope (SEM) and X-ray diffraction (XRD).
并用扫描电镜（SEM）和X射线粉末衍射（XRD）方法对其微观形貌和物相结构进行了观察和检测。
The XRD pattern analysis indicated that the roasting temperature has a decisive effect on the phase composition of the prepared sample.
XRD谱图分析表明，焙烧温度对制备样品的物相组成具有决定性作用。
The form and structure were characterized by means of TEM, XRD and FTIR measurement.
采用TEM，XRD，FTIR等手段对合成样品进行了形貌与结构表征；
X-ray diffraction(XRD) and scanning electron microscopy(SEM) analyses show that the graphite block has an obvious orientation structure.
射线衍射XRD和扫描电镜SEM分析表明，细粒石墨在块体材料中具有明显的取向性。
Using XRD and TG DTG technologies, the phase structure and reduction property of the catalyst are investigated and characterized.
采用X射线衍射和热重分析等手段分别对这种催化剂的物相结构和还原性能进行了表征。
But the Raman shift was still observed. For last series, we were experimented with XRD, reflectance, PL and Raman scattering.
在最后一系列的样品实验中，我们做了X光绕射、反射率、光激发光谱和拉曼散射实验。
XRD, TEM, BET and other means are used to detect and characterize the structural characteristics and properties of the catalyst.
采用XRD、TEM、BET等手段检测和表征了催化剂的结构特性和组分特性，并进行了理论分析。
The phase transformation and weight loss rate of ludwigite in oxidizing roasting were studied by DTA-TG, isothermal TG and XRD.
利用DTA-TG、恒温TG和XRD测试方法研究了硼铁矿氧化焙烧过程中的相变和失重率。
The microcrystal glass was prepared from granite scrap. The microstructure of the products were characterized by SEM and XRD.
以米易县花岗岩废料为主要原料制备微晶玻璃，其显微结构经SEM和XRD表征。
The morphology, properties and microstructure of the coatings were studied by SEM, XRD, and microhardness tester.
用扫描电镜、X射线衍射仪和显微硬度计分析了电火花表面强化层形貌、性能和组织结构。
The morphology of the powders was characterized by transmission electron microscopy(TEM) and X ray diffraction (XRD).
并采用X射线和透射电镜等对颗粒形态进行表征。
The thermal property, phase constitution and micro-morphology of the glass-ceramics were investigated by DSC, XRD, and SEM.
利用DSC、XRD及SEM等研究了铝土尾矿微晶玻璃的热学特性、相组成以及微观形貌。
