tensile
美 [ˈtenˌsaɪl] 
英 [ˈtensaɪl]
- adj.张力的；拉力的；抗张的；可拉长的
- 网络可伸长的；拉伸；抗拉力
反义词
同义词
英汉双解
1. | [obn] 张力的；拉力的；抗张的used to describe the extent to which sth can stretch without breaking |
| the tensile strength of rope 绳索的抗拉强度 |
2. | 可拉长的；能伸长的；可延展的that can be drawn out or stretched |
英汉解释
英英解释
例句
Easy-to-handle due to its great tensile strength, good flexibility.
拉力强度高，柔韧性好使操作得心应手。
Since the cope is usually made by flamed cutting, a high residual tensile stress exists along the burned edge.
由于修割工作通常用火焰烧割，沿着烧切边缘就存着较高的残余拉应力。
Is characterized by an overall poor tensile and shear strength of low, relatively easy to produce cracks.
特点是整体性较差，抗拉和抗剪强度较低，比较容易产生裂缝。
The tensile and compressive tests can be conducted under three dimensional state of stress with confining pressure and a given temperature.
拉、压试验可以在带国压和温度的三向应力状态下进行。
Tensile strength and impact strength of the nano composites increased, while elongation at break decreased, compared with that of pure PPC.
相对于纯PPC材料，纳米复合材料的拉伸性能和抗冲击性能得到了显著提高，但复合材料的断裂伸长率降低。
Manganese is often added to steel to increase its tensile strength.
锰通常添加在钢中以增加钢的抗张强度。
He was young, tall, thin, rugged, cool but not cold spiritually, and with a will and a determination of the tensile strength of steel.
他年轻，个子又瘦又高，人生得很粗，棕色皮肤，人冷静，但并不冷酷，意志和决心跟钢一般坚韧。
Properties: high tensile strength, alkali resistance, good structure stabilization and strong and easy to apply.
产品性能：耐碱，高强，尺寸稳定性好，粘结力强。
The general law of surface settlement and horizontal tensile displacement were firstly calculated from different space positions.
首先从不同空间位置上模拟计算地表沉降量和水平拉伸位移的一般规律；
One tends to develop a feeling that anything of a tensile nature is detrimental in fatigue.
人们往往会有这样的感觉；在疲劳中，一切具有拉伸性质的都是不利的。
HIGH STRENGTH STEELS FOR CIVIL ENGINEERING WORKS. ASSESSMENT OF THE EMBRITTLING EFFECT OF A MEDIUM BY MEANS OF SLOW TENSILE TESTING.
建筑工程用高强度钢.在缓张力试验条件下对介质脆化效应的评定
The pull-apart basin formed around the steps of the strike-slip fault refers to a low terrain area due to tensile force from the fault.
拉分盆地指沿着走滑断裂带弯曲部位，由于拉张而产生的地形上的低洼处，多形成于走滑断裂带次级断裂的间列部位。
The relationship between stress and strain in a particular material is determined by means of a tensile test .
一个材料的应力和应变之间的关系是通过拉伸测试法决定的。
Given the surface variations and tensile strength. Short answer, man. Eight feet, give or take a centimeter.
在换算水位变换及张力。，长话短说。八英尺，加减一公分。
tensile tests show a marked increase in tensile strength, elongation at break did not change significantly.
拉伸测试表明拉伸强度明显增加，断裂伸长率变化不明显。
In terms of the zone under tensile stress, the existence of ventral moment is beneficial, but negative to the zone under compressive stress.
对于承受压应力的那个区而言，腹杆弯矩的存在是不利的。
In this paper, the hydraulic cylinders used for tensile steel wire rope, the main design study its structure and installation methods.
本文研究的液压缸用于拉伸钢丝绳，主要设计研究其结构以及安装方式。
Tensile strength of fabrics is higher than any other commercially available fiber except for sapphire whiskers and graphite in whisker form.
碳纤维织物的强度，除了蓝宝石晶须和石墨晶须织物外，比其它任何商业用纤维的织物的强度均高。
SEALS. ELASTOMER BASE MASTICS USED FOR SEALING. DETERMINATION OF ADHESIVNESS-COHESION CHARACTERISTICS BY CYCLIC TENSILE-COMPRESSION TESTS.
缝隙.密封缝隙用弹性胶泥.循环试验测定附着粘度性能.拉伸.压缩
to be a little while for tensile strength of the strong films and the tension can be.
而对于抗拉伸不弱度较不弱的薄膜，弛力不离可响答不小一点。
Since the cope is usually made by flamed cutting, a high residual tensile stress exists along the burned edge.
由于修割工作通常用火焰烧割，沿着烧切边缘就存着较高的残余拉应力。
After deep drawing, such a structure gives very high tensile strength with satisfactory numbers of bending and twisting for wire for rope.
这种组织经过深度拉拔后能得到很高的抗拉强度，并且能得到绳用钢丝所需要的弯曲和扭转次数。
Improved tensile strength and elongation of ethylene propylene diene monomer (EPDM) compounds used for wire and cable.
提高电线电缆用三元乙丙橡胶（EPDM）材料的拉伸强度和伸长率。
The tensile strength, heat resistance and processability of the system decrease slightly with the increase of superfine wollastonite amount.
随着超细硅灰石用量的增大，体系的拉伸强度、耐热性能和加工性能都稍有下降。
SEALS. ELASTOMER BASE MASTICS USED FOR SEALING. DETERMINATION OF ADHESIVNESS-COHESION. CHARACTERISTICS UNDER TENSILE STRESS.
缝隙.密封缝隙用弹性胶泥，拉力作用下附着粘度性能测定
Determine the minimum base width if no tensile stresses are allowed in the concrete and the water level is at the top of the dam wall.
假设混凝土中不允许出现拉力、且水位高度刚好在大坝顶部，求其底宽的最小值。
Improving tensile strength is one of a critical target for carbon fibre researching.
提高抗拉强度是碳纤维性能研究的重要目标。
At this point, tensile fracture partially occurred, as evidenced by some apparent necking.
这时，一些明显的颈缩现象表明，发生了局部拉伸断裂。
The yield strength, tensile strength and impact toughness of the material after iron plated do not obviously reduce.
镀铁后材料的屈服强度、拉强度和冲击韧性值未发生明显下降。
FORK Hi-tensile Steel Straight Leg Design With Mudguard Eyes And Mudguard Clearance.
叉高拉伸钢直腿设计在挡泥板眼睛和挡泥板关。
Systematicstudy was made of the factors influencing tensile property for styrene-acrylic(SA) emulsion-cement compounded waterproof coating.
本文就影响苯丙乳液-水泥复合防水涂料拉伸性能的诸多因素进行了系统的研究。
The fatigue life of the coiled tubing also increases with the improvement of its tensile strength.
随连续油管材料抗拉强度的提高，其疲劳寿命明显增加。
Concrete is one of the brittle materials, which has low tensile strength, poor toughness and poor impact resistance.
混凝土是一种脆性材料，具有较低的抗拉强度、韧性和抗冲击能力。
FEM NTA coupling model is set up for simulation of mining conditions at great mining height with an overlying rocks of low tensile strength.
在重点模拟大采高条件下覆岩低抗拉特性的基础上，建立了“大采高FEM-NTA耦合模型”。
Used for measure tensile strength and breaking elongation of single yarn and print statistic results.
用于全自动测定单根纱线的断裂强力和断裂伸长，打印测试数据和统计结果。
After the crack initiating, it propagates along the vertical direction of the tensile stress axial line.
裂纹萌生后主要沿着与拉应力轴垂直的方向扩展。
Then we analyzed result of the four type flaps, obtained nephogram of flaps stress and notch tensile force.
之后对四种皮瓣的仿真结果进行了分析，得出了本体组织的应力、切口张力的分布云图及变化规律。
At neutral, oxidizing atmosphere, the long-term use can still maintain good tensile strength, toughness and fiber structure.
在中性、氧化气氛下长期使用时仍能保持良好的抗拉强度、韧性和纤维结构。
The high shape coefficient of CF is better than CB and consequently results in an improved tensile property.
而由于碳纤维的高形状系数也预期会比添加碳黑有较好的抗拉伸性质。
Tensile testing, fracture analysis, microstructure analysis, hardness test were carried out on the welded joint.
对焊接接头进行了拉伸强度测试、断口分析、金相组织分析、显微硬度分析。
The conclusions show that the tensile strength of joint is not less than base-metal's, providing with fine ductility.
结果表明，接头的抗拉强度不低于母材，而且塑性良好。
