HAZ
美 
英
- n.焊接件的受热区
- 网络热影响区(heat affected zone)；焊接热影响区；热影响区域
英汉解释
例句
The results show that the welding thermal-cycle on its mechanical property of the HAZ has no evidence effect.
结果表明，焊接热循环对其热影响区的性能没有明显的影响；
The weld section looks like an inverted trapezia and the heat affect zone (HAZ) is very narrow.
焊缝截面呈上宽下窄的倒梯形，热影响区（HAZ）相当窄；
Fibrous processing marks remain in the heat-affected zone (HAZ) with part of precipitated solid phase solved into the base metal.
热影响区内，仍可见纤维状加工痕迹，部分析出相固溶到基体中；
The microstructure of weld bead obtained by shielded metal arc welding are massive ferrite and a little pearlite, HAZ are lath bainitic.
手工电弧焊焊缝组织主要为块状铁素体和少量珠光体，热影响区组织为板条状贝氏体组织；
The microhardness distribution of the welded joint is along the welding line. The microhardness is higher in nugget zone, and lowest in HAZ.
焊接接头的硬度分布沿焊缝中心基本对称，焊核区硬度较高，热影响区硬度最低。
high strength pipeline steel pipes and its welding HAZ shall have well properties of low temperature toughness and site girth welding.
以得到同时具备高强度、良好的低温韧性和现场焊接性能的管线钢。
This paper discussed the effects of Nb on the HAZ structure and properties of ultra-fine grained steel formed by the deformation inducement.
讨论了以形变诱导相变为主的超细晶粒钢在添加合金元素铌以后热影响区组织性能的变化。
The HAZ will have O temper annealed properties for non-heat-treatable alloys regardless of the initial material temper.
对于不可热处理的合金，HAZ将会得到基础状态O的退火性能。
the HAZ was martensite and a small amount of residual austenite.
热影响区为马氏体组织和少量残余奥氏体。
The dominant nucleation mechanism of IAF in HAZ of different micro-alloyed series was not the same as each other.
不同微合金化系列占主导地位的IAF形核机制不尽相同。
The results indicated that excellent low temperature toughness and lower FATT could be obtained under different welding conditions in HAZ.
结果表明：在不同焊接条件下，此类钢焊接热影响区均具有较好的低温韧性和较低的韧脆转变温度。
The grain distribution and heat pining of grain growth in the welding HAZ. Different influence were predicted by different heat input .
预测了HAZ中晶粒的分布，以及不同的热输入对HAZ晶粒长大的影响和HAZ中晶粒长大的热钉扎效应。
A recent vice president, Hamzah Haz, bragged about his polygamy, taking his three wives on trips to Mecca.
曾任印尼副总统的哈姆扎•哈兹（HamzahHaz）曾经公开炫耀他的多重婚姻，带他的3位太太去麦加朝圣。
Fracture toughness of heat affected zone (HAZ) was between the base metal and weld metal.
焊接热影响区的断裂韧性介于母材和焊缝金属之间。
The test result shows that jointer weld is typically ferrite and pearlite structure, HAZ contains side strip ferrite.
试验结果表明，该钢焊接接头焊缝为典型的铁素体和少量的珠光体组织，HAZ（热影响区）含有侧板条铁素体。
On the basis of the microhardness variation, the HAZ is divided into five subregions .
根据显微硬度的变化，将焊接HAZ分为五个区段。
With the increase of yield strength, the longitudinal residual stress of HAZ increases.
且随着焊缝强度增加，热影响区纵向残余应力增加。
The hardness of the weld zone is higher than that of matrix and the hardness of heat affected zone(HAZ) is lowest.
焊缝区显微硬度最高，其次是母材，热影响区硬度最低。
declining of mechanical performance in welding seam and welding heat affected zone(HAZ) etc.
焊缝和焊接热影响区力学性能下降等不足。
The microhardness of weld metal zone, HAZ and base metal decrease in totality after heat treatment.
焊缝区、热影响区与母材的显微硬度整体呈下降趋势；
Toughness distributions of different area on HAZ of grade X80 pipeline steel have been studied.
研究了X80级管线钢焊接热影响区不同区域的韧性分布。
Both FZ and HAZ have higher microhardness than the base metal has, and microhardness in fusion centre zone is the lowest.
熔合区和热影响区的显微硬度显著高于母材，焊缝中心区在整个焊缝部分硬度最低。
There ate a small amount of martensite in HAZ, and distributed in gradient.
热影响区中存在少量细小马氏体组织，且呈梯度分布。
The micro-structure of fracture surface of HAZ is of granular bainite, with characteristics of coarse crystal zone.
热影响区断口表层剖面组织为粒状贝氏体，显示出粗晶区的特征。
It was shown that the impact toughness of HAZ is 50% of base metal.
结果表明，该钢的焊接热影响区的冲击韧性较母材降低50%以上；
Too slow a cooling rate can result in a soft HAZ and thus a loss of tensile and fracture toughness properties.
如果冷却率太慢，则会导致软焊接，张力减少和韧性变脆。
The results show that dislocation starts to glide in HAZ.
结果表明：热影响区位错开始滑移；
Any arc welding process gets the HAZ much hotter than this.
电弧焊接工艺将使HAZ（焊接热影响区）比这个更热。
The actual welding test show that the grain size number in HAZ is above NO. 6.
对该钢种进行了实际焊接试验，检测结果表明热影响区的晶粒度在6级以上。
Four kinds of welding joints all have good low-temperature impact toughness except HAZ on 1. 4003 side.
除1.4003侧HAZ外，四种焊接接头均具有良好的低温冲击韧性。
Impact Charpy toughness and local brittleness of HAZ of X80 line pipes made in China were studied.
研究了国产X80级管线钢热影响区的冲击韧性和组织的局部脆化。
Prediction of HAZ tribological properties of fusion welded zinc-based alloy by means of artificial
基于人工神经网络的锌基合金熔化焊HAZ摩擦学性能预测
Flow behaviors of HAZ-softened weld joint and prediction of its tensile strength
热影响区软化焊接接头流变行为及抗拉强度预测
Effect of welding thermal cycle on HAZ microstructure and mechanical properties of copper-bearing age-hardening steels
焊接热循环对含铜时效钢HAZ组织与力学性能的影响
Study on HAZ microstructure and impact properties in high strength shipbuilding steel plate
高强度造船板热影响区组织和冲击性能的研究
Effect of simulated welding thermal cycle on microstructure and properties of HAZ for micro-calcium steel
焊接热循环对微钙钢组织性能的影响
Narrowing HAZ During Induction Heating for Friction Welded Joints of High Strength Steel
高强钢摩擦焊接头感应加热区宽度窄化技术
Monte carlo computer method for simulating microstructure evolution in HAZ of welds
焊接热影响区微观结构演化的蒙特卡罗计算机模拟方法
Modeling and experimental study on HAZ grain growth in laser welding of ultra-fine grained steel
超细晶粒钢激光焊接HAZ晶粒长大的数学模型及实验研究
Microstructure simulation in the HAZ of industrial pure aluminum
工业纯铝焊接热影响区微观组织模拟
