epoxy
美 [ɪ'pɒksi] 
英 [ɪ'pɒksi]
- adj.环氧的
- n.环氧树脂
- 网络环氧树酯；环氧基树脂；环氧树脂胶
词形变化
复数：epoxies 现在分词：epoxying 过去分词：epoxied
英汉双解
1. | 环氧树脂a type of strong glue |
英汉解释
英英解释
例句
Easy to apply just like conventional interior decorative paints. Once cured, its epoxy resin strength ensures High performance.
像普通的室内装饰涂料一样方便使用，一旦固化性能极高。
It's a blend of strong solvents for cleaning of tools that have been used for mixing or application of two-component epoxy paints.
一种有多种强溶剂的混合物。用于洗涤混合或施涂过双组份环氧漆的施工工具。
For the loggerhead's rough shell, the team uses a harmless epoxy, and a base plate which will slough off after a few days.
而对于红海龟那表面粗糙的外壳，考察队需要使用一种无害的环氧树脂和一个基底盘来固定摄像机，所使用的地盘会在几天后脱掉。
Now, the company admits that the epoxy liners in its bottles used to contain trace amounts of BPA.
现在，公司承认在它的这个水壶里面的环氧衬里里面曾经含有微量的BPA。
The box girders were to be precast units, bonded together in place at the joints with an epoxy resin.
箱梁采用预制构件，在现场连接处涂以环氧树脂，以粘结成为整体。
A filler made of an epoxy resin is formed around the substantially cylindrical units.
由环氧树脂制成的填充体形成在基本上圆柱形单元周围。
The improvements of gas chromatography method used to determine epoxy chloropropane in the air and waste air are discussed and tested.
通过实验探讨了气相色谱法测定空气和废气中环氧氯丙烷的改进方法，并加以验证。
epoxy resin glue seems to be easier than solder paste bonded scraper.
环氧树脂胶水仿佛比锡膏更便当粘结在刮刀上。
The test result indicates that this epoxy resin material has a better mechanical relaxation behavior under a lower temperature condition.
试验结果表明该环氧修补材料在低温情况下具有较好的力学松弛性能。
The body of valves is printed by powdered epoxy, can be prevent the corrosion and rusting, can be used to sewage system.
阀体采用粉体环氧树脂涂装，可防止阀体的腐蚀及生锈，并可用于污水系统。
SUPERIOR EPOXY PRIMER 171 will penetrate into concrete, sealing the surface to improve adhesion of epoxy toppings and coatings.
171型高级环氧底漆能够渗入混凝土，密封表层，以提高环氧封顶和面漆的黏着性。
The handle is of malleable iron with epoxy coating. The throttling index plates are made of zinc-plated steel.
手柄是可锻铸铁，环氧树脂涂敷。节流刻度板由镀锌钢制成。
Experiments showed that progressive failure was the main feature of glass epoxy cylindrical shells subjected to axial impact.
玻璃-环氧圆柱壳（管）的撞击试验表明它的破坏是渐进过程。
tuyere: aluminum alloy shutter, the surface was electro -sprayed by epoxy resin.
补风口：采用铝合金百叶窗，表面环氧树脂喷涂。
Mounting of the LCD driver wafer on the PCB with gold wires used to connect it to other circuits. It is covered with epoxy.
在PCB上LCD维夫饼乾的安装用过去常常把它和其他电路连结起来的金电线。它被盖住由于环氧。
Can be precoated with epoxy, phenolics, epoxy coal-tars, vinyls , polyurethanes, chlorinated rubber, acrylics, or other as recommended.
可以复涂以环氧、酚醛、环氧煤焦油、乙烯基、聚氨酯、氯化橡胶、丙烯酸，以及其他推荐配套涂层。
We researched the preparation of the magnetism ferric oxide epoxy primer through a serious of experiments, based in consulted information .
通过实验，研究了磁性氧化铁环氧底漆的制备，检测了其各项性能指标。
Such thermosetting resins as phenol-formaldehyde resins, ployester resins, and epoxy resins do not belong to this classification.
像酚醛树脂、聚酯树脂和环氧树脂等热固性树脂不属于此类。
The invention relates to an epoxy nano composite anticorrosion coating for low surface treatment and a preparation method thereof.
本发明涉及一种环氧低表面处理纳米复合防腐涂料及其制备方法。
It is mainly used for producing epoxy ethane with ethylene, formaldehyde with methanol and producing ethylene glycol.
银作催化剂用的场合不多，主要用于乙烯氧化制环氧乙烷、甲醇氧化制甲醛及乙二醇的生产。
Such thermosetting resins as phenol-formaldehyde resins, ployester resins, and epoxy resins do not belong to this classification.
像酚醛树脂、聚酯树脂和环氧树脂等热固性树脂不属于此类。
currently , only a small proportion of our laminate sales are generated from mass - demand , thin glass epoxy laminates.
目前，需求大之薄环氧玻璃纤维覆铜面板，仅占公司覆铜面板销售额很小比重。
The results show that the aging resistance performance of the epoxy structural adhesives can be improved obviously by compound method.
试验结果表明：采用固化剂复配的方法可以显著提高环氧结构胶的耐老化性能；
The results showed that the electrical properties of bisphenol A based epoxy resin cured by modified anhydride wane better than any others.
结果表明，双酚A环氧树脂与改性酸酐的固化产物电性能较好。
The advanced performances of epoxy glass fibre reinforced plastic have been proved through reports of many practice application examples.
玻璃纤维增强的环氧树脂的优良性能已为许多实例的报道所证实。
A new epoxy resin plant alongside the planned glass epoxy laminate factory will be set up in Jiangyin, Jiangsu province.
集团计划在江苏省江阴的环氧玻璃纤维覆铜面板厂附近增设一家环氧树脂厂。
In this paper, using ground-based simulation facilities, the vacuum thermal cycling test was carried out on the epoxy construction adhesive.
本文利用空间环境效应地面模拟设备，对环氧结构胶粘剂进行真空热循环试验。
The surface is sprayed with epoxy resin with high corrosion resistance .
表面环氧树脂喷涂，防腐性能好。
So if I get something done, like epoxy the hatches of the kayak I'm building, it's a great day.
所以，如果我干成了件什么事，如给我自己建造的皮艇舱口刷环氧树脂，我就度过了伟大的一天。
It was found that the mechanical properties of epoxy nanocomposites showed significant improvement with the content of silica nanoparticles.
研究结果表明高性能环氧树脂的力学性能随着纳米颗粒的添加能够得到明显的改善；
Curing Time : The time needed to complete curing of an epoxy at a certain temperature .
固化时间：环氧树脂在特定温度下完全固化所需要的时间。
The invention discloses epoxy resin modified by isocyanate terminated silicon rubber and a preparation method thereof.
本发明公开一种端异氰酸酯硅橡胶改性环氧树脂及其制备方法。
It was found in this experiment that the epoxy resin had the varying degree influence to the several properties of polysulfide sealant.
试验发现，环氧树脂对聚硫密封胶的多项性能都有不同程度的影响。
The master molds are first made of wood or plaster of Paris. They are then reproduced as copies in an epoxy material.
主要的模具起初是木制的或是巴黎石膏制成的。然后用环氧化的材料通过它们再次加工做出复制品。
The automatic grinding machine is multifunctional, also can be treated against epoxy resin, but chemical process is not possible.
自动研磨机可以研磨线路板上之树脂，可一机多用；而化学方法则不可以。
The technique is applied to measurements of microscale deformation fields within an adhesive joint in a carbon-fiber epoxy composite.
该技术适用于微尺度变形测量领域内的胶粘剂联合在碳纤维环氧复合材料。
The adhesive strength and strength of resistance to impacting for the metal manufacture is better than normal epoxy.
对金属物品之接著，耐冲击强度优于环氧树脂。
It was found that, the self-assembled interfacial monolayer can improve the corrosion protection of the epoxy coating greatly.
结果表明，引入的自组装单层可极大地改善涂层的腐蚀防护性能。
In this method, reliefs , plates, figure and animal shape, etc, which made of glass epoxy, are evaporated, and the results are perfect.
用真空蒸发镀镜机镀制了玻璃钢浮雕、花盘、线条及人物和动物造型等，取得了理想的装饰效果。
The sliding layer consists of strands of high-strength polyester and reinforced PTFE (polytetrafluoroethylene) in an epoxy resin matrix.
滑动层由成束的高强度聚酯和环氧树脂基增强PTFE（聚四氟乙烯）组成。
Since then, the company switched to spray epoxy resin, and surface treated more laser engraving.
此后，该公司改用表面喷涂环氧树脂，然后在滚筒表面经处理再进行激光雕刻。
