annealed
美 
英 [ə'ni:ld]
- v.给…上釉；【冶】使韧化；〈比喻〉锻练(意志)
- 网络退火；退火的；退火状态
词形变化
过去分词：annealed 现在分词：annealing 第三人称单数：anneals 同义词
英汉解释
英英解释
例句
The washer is usually made of annealed nickel and has a highly polished surface.
垫圈通常用退火镍制成，具有非常光滑的表面。
Hot rolled stainless steel bars that are annealed and cold worked to produce a higher surface quality and higher strength.
经过退火及冷加工的热轧不锈钢棒材，其表面质量更高，强度也更高。
When gill hole was enlarged and handlers was formed after annealed, the surface shallow crack and chap appeared.
当锻件退火后进行鳃孔扩口和柄部弧形弯曲时，过热和过烧的缺陷引起表面浅层裂纹和龟裂。
Bearing cones must be annealed prior to machining and a subsequent post heat-treat hardening.
退火轴承锥必须事先向加工和随后的后热处理硬化治疗。
In this paper the annealed structure and its grade of bearing steel with abnormal original structure have been studied.
本文研究了非正常原始组织的轴承钢，退火后的组织及其评级问题。
The copper is slowly drawn through the die in extremely small increments and is annealed following each drawing operation.
铜正在慢慢穿过死在非常小的增量和退火以下是每个绘图作业。
Temper-all material shall be thoroughly and evenly annealed, and dead soft, unless otherwise specified by the purchase order.
除非采购订单另有规定，否则所有材料的回火应该彻底而均匀地退火，完全软化。
Other flat-rolled products of stainless steel, hot-rolled, not annealed and pickled, not in coils, of a thickness exceeding 10 mm.
其它热轧不锈钢扁轧制品，未经热轧退火酸洗，非卷盘状，厚度超过10公厘者。
The experiments show that the microstructure of annealed sample is favourable to improving reverse breakdown voltage.
实验表明，退火后样品的微观结构有利于提高反向击穿电压。
When it is annealed, amount of cokes are put into the furnace which is sealed up to prevent the oxidization of mould.
在进行退火处理时，退火炉内放入一定量的焦炭，并且将炉门四周密封，防止铸钢件表面氧化。
The HAZ will have O temper annealed properties for non-heat-treatable alloys regardless of the initial material temper.
对于不可热处理的合金，HAZ将会得到基础状态O的退火性能。
According to the size of carbides and the amount of exposed matrix, the annealed structure can be divided into low and high grades.
认为可以根据碳化物颗粒大小，基体露出多少为主的原则，把其分为低级别组织和高级别组织进行参考评级。
The variation of the texture and magnetic properties of non-oriented silicon steel after being cold-rolled and annealed is studied.
对冷轧及退火后无取向硅钢织构及磁性能的变化进行研究。
Bending can be done in a umber of ways, but prior to this, the lever must be annealed so that it doesn't crack during reforming.
弯曲的方式进行，可在一个单位数目，但在此之前，必须退火的杠杆，以便它在改革不开裂。
Most nonferrous metals can be annealed, but never tempered, normalized, or case-hardened.
而大多数有色金属可以进行退火，但不能进行正火或者表面硬化。
The resistivity of pyrophosphate and annealed acid sulfate copper deposits are substantially equivalent.
焦磷酸盐和退火后的酸性硫酸铜沉积物的电阻性是基本等效的。
In the first, it is annealed, meaning it is run through a furnace to be softened.
在第一，它是退火，这意味着它是通过一炉运行到软化。
A. For annealed drawn tubes the ratio of outer diameter to thickness is no more than 15.
退火态拉制管外径与壁厚之比不小于15者。更详细。
However, the forward martensitic transformations were greatly suppressed in annealed Co and CoNi.
然而钴和钴镍中的马氏体正相变则大大的压制。
which appeared quite different from aforementioned results obtained from the annealed ZnO sample.
出现上述结果不同从退火氧化锌样品。
Lead or annealed copper washers are most often used in fluorine and other reactive fluoride service.
铅或退火铜垫圈最经常用于氟和其它活泼氟化物设施。
The effect of different annealed process on the property change of the resistance thermostat metal is investigated.
本文研究了不同的退火工艺对电阻系列热双金属性能产生的影响。
The EDS analyses also suggest the presence of burnt carbonaceous residues on the annealed sheet surface.
有关的EDS分析还表明，存在烧毁的碳质残留对退火板表面。
CASTING TO BE ANNEALED AND FULLY STRESS RELIEVED.
铸造将予应力退火和时效处理。
The samples prepared were annealed in air atmosphere at different temperatures.
在空气中对样品进行不同温度的退火处理。
Therefore, the design must be based on the annealed properties, not on the strain-hardened properties.
因此，设计必须基于退火性能，而非应变硬度性能。
Standard Specification for Annealed Copper- Clad Steel Wire . Pdf.
退火火铜包覆钢丝电线规范。
If a CroMo frame is not heat treated after welding, the joints subjected to heat during the welding process are annealed or normalized.
如果CroMo框架焊后不热处理，关节受高温焊接过程中退火或正常化。
While the oxide scale of the 316 steel annealed in air was quite complicated and has a very poor bonding with the substrate.
而在空气炉中生成的氧化层结构复杂，和基体的结合强度非常低。
The change rule of the microstructure of the coldrolled Sisteel annealed under different current was researched.
研究了不同电流条件下退火冷轧无取向硅钢组织的变化规律。
A series of improving technical methods were addressed for arising the quality of annealed metal base.
为提高金属坯条光亮退火的质量，提出了一系列工艺改进的方法。
In this process the cold rolled annealed strips are given a desired surface finish.
在这一个加工，卷退火的分带寒冷有一个被需要的表面光制。
The precipitated phases in cold rolled and annealed thin steel strip are nano-scaled M3C and nano-scaled MC.
冷硬板和退火薄板中的析出相主要为纳米级的M3C型和MC型析出物。
Appreciate those who hurt you, because he annealed your mind.
感激伤害你的人，因为他磨练了你的心志。
And cracks appear in the film because tensile stress is too large when the sample is annealed at 400 centigrade.
在400℃退火后，由于张应力太大，薄膜表面出现了裂纹。
Annealed tool steel can readily be machined.
加热退火工艺炼钢能通过机械简单完成。
At the second one, the products in the first step were annealed at different temperatures to obtain 1-D ZnO.
第二步骤则是将前一步骤的产物经过不同温度的退火处理来得到一维氧化锌材料。
Irradiation creep of annealed 304L stainless steel at low dose levels.
在低剂量水平下退火304L不锈钢的辐照蠕变…[中国核科技信息与经济研究院]。
Hardened steel is difficult to machine, but having been annealed, it can be easily machined.
淬火钢难于加工，但是经退火后就易于加工了。
for annealed metals, it is about five times Y.
而对于退火材料来说，则大约是五倍。
